Wednesday, 18 November, 2026

Copper or Aluminium Conductor? A Power Cable Buyer’s Guide


Conductivity and the "one size up" rule

Annealed copper is the benchmark for electrical conductivity, set at 100% IACS. Aluminium reaches roughly 61% IACS, so an aluminium conductor must be about 1.6 times the cross-section of a copper conductor to carry the same current with comparable losses. That is why the industry rule is to go one nominal size larger when switching from copper to aluminium — 95 mm² aluminium replacing 70 mm² copper, for example. If a design is simply swapped material by material without resizing, voltage drop and temperature rise will both increase.

Weight and mechanical load

Aluminium is far lighter per unit volume, and even after the size increase an aluminium cable is typically around half the weight of the copper equivalent for the same ampacity. On long overhead spans, in aerial insulated cable, and during manual pulling in confined trenches, that weight difference reduces tension on conductors, supports and installation crews. Copper's higher density, on the other hand, gives it better resistance to vibration and mechanical stress in some industrial applications.

Corrosion, creep and termination

This is where aluminium earns its reputation for trouble. Aluminium forms an insulating oxide layer instantly on exposure to air, so joints must be properly prepared and pasted or plated. It also creeps under sustained terminal pressure, which loosens connections over time, and its coefficient of thermal expansion is higher than copper, adding to the movement at joints. Aluminium-to-copper connections need bimetallic lugs or suitable transition plates; connecting them directly in a damp location creates a galvanic couple and eventual failure. Copper terminations are simpler and more forgiving, which matters on projects where workmanship cannot be tightly supervised.

Cost, availability and security

Aluminium is significantly cheaper per kilogram and per ampacity, and it is lighter to ship and easier to handle on site. Copper carries higher scrap value, which raises the risk of cable theft on remote or unattended sites — a real cost factor for rural distribution and construction projects. Where budget is tight and load is moderate, aluminium is often the pragmatic answer; where connection reliability, compact size and low maintenance dominate, copper justifies its price.

Where each material belongs

Copper is the safer default for control and instrumentation circuits, flexible cords, equipment wiring, short LV distribution runs, and any location with tight space, high ambient temperature or difficult maintenance access. Aluminium is widely and successfully used for medium and high voltage feeders, long overhead and aerial insulated lines, and large LV distribution feeders where the extra cross-section is available and terminations can be made by trained crews with proper fittings.

What to check before you order

Ask for the conductor class (plain or tinned copper, annealed aluminium), the exact nominal cross-section, and the standard the cable is tested to. Confirm that the terminations specified by the electrical contractor match the conductor material. And require routine test reports — DC resistance in particular, because conductor resistance is where cheap, undersized or impure metal shows up first.

Jiangsu Dadi Cable produces copper and aluminium core power cables, aerial insulated cables, low voltage and medium/high voltage XLPE and PVC cables, with DC resistance, partial discharge, mechanical and thermal testing carried out in-house in a CNAS-certified laboratory. Tell us the installation conditions and load profile, and our engineers will confirm the conductor material and size that actually meets your design.

Compare copper and aluminium core power cable specifications at http://www.dadigroup-cable.com/

www.dadigroup-cable.com
Jiangsu Dadi Cable Co., Ltd.

0 comments on “Copper or Aluminium Conductor? A Power Cable Buyer’s Guide”

Leave a Reply

Your email address will not be published. Required fields are marked *