Two materials, two different structures
PVC (polyvinyl chloride) is a thermoplastic. It softens when heated and hardens when cooled, which is a physical change only. XLPE (cross-linked polyethylene) starts as a thermoplastic but is chemically cross-linked during production, turning it into a thermosetting material that no longer melts at operating temperature. That structural difference explains most of the performance gap between them.
Temperature rating and current capacity
The continuous conductor temperature limit for PVC insulated cable is normally 70°C, while XLPE is rated at 90°C, with a short-circuit allowance up to 250°C against 160°C for PVC. In practice, an XLPE cable of the same conductor cross-section carries roughly 15–25% more current than its PVC equivalent. On a project with fixed conduit sizes or limited space in a cable trench, that difference can remove the need to go up a size — or make a PVC design fail the load calculation outright.
Service life and ageing behaviour
PVC insulation tends to harden and lose plasticity over time, especially in hot, oily or outdoor environments, and its dielectric losses are higher. XLPE has lower dielectric loss and better resistance to thermal ageing and moisture, which is why it dominates medium and high voltage distribution as well as most industrial LV power runs. For a dry indoor lighting or small appliance circuit, PVC is entirely adequate. For anything carrying load continuously, in wet or buried conditions, XLPE is the more durable choice.
Fire performance — read the whole picture
PVC is inherently flame retardant because of its chlorine content, but it releases dense, corrosive hydrogen chloride gas and heavy smoke when it burns, which damages equipment and obstructs evacuation. XLPE burns more readily on its own, so it is supplied in flame-retardant or low-smoke halogen-free (LSZH) compounds where fire safety matters: tunnels, metro stations, hospitals, data rooms and crowded public buildings. On projects with strict fire specifications, neither material should be ordered without checking the flame-retardant and fire-resistance marking required by the design.
Cost is not the same as total cost
PVC compound is cheaper, so a PVC cable usually wins on purchase price. But once you account for a larger conductor size to hit the same ampacity, shorter replacement cycles in hot environments, and the cost of re-terminating or re-pulling a failed run, XLPE frequently comes out cheaper over the life of the installation. The right comparison is cost per ampacity per year in service, not price per metre.
A practical rule of thumb
Use PVC for short, dry, lightly loaded runs — building wiring, control panels, indoor flexible connections such as RVV cord. Use XLPE for medium and high voltage cables, long LV distribution feeders, buried and outdoor runs, and any circuit where continuous load and thermal margin matter. Where both are quoted, ask for the derating calculation rather than comparing only the price column.
How the cable is made matters as much as the compound
Insulation quality depends on how cleanly the material is applied. Jiangsu Dadi Cable runs two chemical cross-linking production lines using three-layer co-extrusion fully dry cross-linking, monitored by German SIKORA online deviation measuring instruments, with production and feeding carried out in enclosed high-cleanliness conditions. Every batch is then checked in a CNAS-certified testing centre covering partial discharge, DC resistance, electrical and mechanical performance, thermal extension and fire resistance — so the XLPE or PVC you specify is the one you actually receive.
Whichever insulation you choose, specify the standard, the flame-retardant class and the test reports together, and let the cable manufacturer confirm the ampacity for your installation conditions.
Learn more about low voltage and medium voltage power cables at http://www.dadigroup-cable.com/
www.dadigroup-cable.com
Jiangsu Dadi Cable Co., Ltd.
